Turbobike Web Site www.Turborick.com

[turbobike] CV carb jetting

Doug Cutler (DCutler@Mundaca.com)
Mon, 10 May 1999 10:43:30 -0500

I have a Buell with an Aerocharger. The kit is designed around stock 
heads. When I did my install I put in dual plugs and had the heads 
ported. Flow chart shows about 35% improvement across the board. The 
carb is a blow thru. Problem: At idle with a #45 jet I seem to be a 
little rich, burbles on take off but clears out fairly quickly. Idle 
jet screw has almost no effect on idle speed. (factory recommends 48 
jet).  At about 4000 rpm I have the opposite problem, it flat runs out 
of fuel, but picks up and staggers  to about 5000 rpm where it lays 
over altogether. Main jet is drilled out  to 235 (?) .  Float set at 
.550 , electric fuel pump. Diaphram OK. Any ideas ?        Swamp 
Boogie Doug