Turbobike Web Site www.Turborick.com

Re: [turbobike] Main jet question

Dave Morrill (david.p.morrill@fairchildsemi.com)
Mon, 29 Nov 1999 09:01:34 -0500

> Hello,

    I had this prob with mine, down low (off boost) it was way rich and
numb.  At low RPM, no boost, your not on the main jet (especially w/ Keihin
CV's).  Your on the pilot jets.  I had to make a special tool to adjust these
to lean out the bottom end (Honda wanted $100 for it).  You should also put
your needle in the lowest clip setting (needle down as far as possible), then
set your main jet at WOT full boost.

    If you don't have an O2 sensor get one, your just guessing if you don't
have one.

good luck,
Dave.